Ethernet Interface 225
Spanning Tree Instances
The Spanning Tree logic supports a maximum of 255 physical and virtual ports, thereby allowing a maximum of 254 ATM VCs. (One Ethernet port is required be set aside for other purposes.)
For the purpose of Spanning Tree operation, each set of one Ethernet port and its associated ATM VCs is treated as one bridge entity. The STAP module runs a separate instance for each bridge entity. Since the PathBuilder S600 shelf can be filled with a maximum of three Ethernet cards, each with two Ethernet ports, a maximum of six instances of STAP can be running on the management card.
Each STAP instance runs independently of the other STAP instances and processes configuration packets as if they came from a different physical bridge device. This approach helps segregate Ethernet ports completely for the purposes of bridging and Spanning Tree and enables the PathBuilder S600 to operate as six separate bridges.
For instructions on enabling and disabling the Spanning Tree, see “Enabling and Disabling the Spanning Tree”in Chapter 4.
Addressing
The next bridging operation is to determine if a packet is addressed to another unit on the LAN (in which case it can be rejected) or if it is addressed to a unit across the bridge.
Each Ethernet packet includes a source address and a destination address in its header. These are MAC addresses which are unique physical addresses assigned to every Ethernet interface on every Ethernet LAN. Packet transmission from one unit to another on the same LAN is easily accomplished. However, packet transmission between units on different LANs requires a
ATM networks are organized into virtual circuits or logical duplex paths between two ATM unit ports as shown in Figure 163.
Each transmission direction in a virtual circuit is referred to as a virtual channel. Virtual channels are then grouped into virtual paths between two ports. The channels and paths are assigned numbers; VPIs (Virtual Path Indicators) and VCIs (Virtual Channel Indicators). Each ATM cell (a