3Com S330 manual Config. Abort is generated

172CHAPTER 5: PATHBUILDER S330 DIAGNOSTICS AND PERFORMANCE STATISTICS

Table 28 DS1/E1 UNI Module Alarms (continued)

Alarm Meaning Troubleshooting Steps

BAD SCCI	Status and Change Control
(3Com Patent	Indication – the content of the
Pending)	ICP cells has changed. The far
	end ICP cell SCCI in this link
	does not agree with the SCCI
	of the other links in the group.

Check the links for proper connection. Reconnect if necessary.

Bad Symmetry	The far end group symmetry
	has changed in an IMA link.
Duplicated IMA ID	An IMA group has received an
	IMA ID that has been received
	by a previous group. The
	second group must have a
	unique IMA ID.

Remove the link and stop Tx and Rx data.

Check for loops and check the IMA group configuration.

Duplicated Link ID	Duplicated far end logical link
	ID in this IMA group for this
	IMA link.
	Each IMA group assigns a
	unique Transmit link ID to each
	link in the group. This link ID
	should match the Receive link
	ID of the remote end IMA
	device. This alarm means that a
	link received a Transmit link ID
	already assigned to a previous
	link.
Duplicated Offset	Duplicated far end ICP cell
	offset in this IMA group in an
	IMA link.
	Each IMA group assigns a
	unique Transmit offset to each
	link in the group. This alarm
	means that a link received a
	Transmit offset already
	assigned to a previous link.
	Some of the links are probably
	misconnected.
Excessive Link Delay	The link has exceeded the
	user-selectable value for
	acceptable link delay.
	The link is removed from the
	group.
Group [n] Abort	Generated when Group [n]
Symmetry	Config. Abort is generated,
	due to group symmetry
	problem

Check the links for proper connection. Reconnect if necessary.

Check the links for proper connection. Reconnect if necessary.

Check the links for proper connection. Reconnect if necessary. Also try adjusting the link delay parameter for the IMA group.

Check and correct near end symmetry. Only symmetric operation is supported in PathBuilder products.

Group [n] Config	The near end node rejects the
Abort	far end IMA parameters.
ATM Forum (R-128)
Group [n] Degraded	The IMA group is passing data
Service	with less than the number of
	IMA links you configured.
(continued)

Check and correct the near end and far end parameters for compatibility.

Continue passing data. Correct faulty links or adjust IMA group configuration.