
100CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS
Table 24 Possible IMA LInk Failure Status Conditions
Failure | Description |
|
|
link failure | This is caused by LOS, AIS, OOF, or LCD. |
LIF failure | This is caused by LIF. |
LODS failure | This is caused by LODS. |
Misconnected | This is caused by bad IMA ID, bad link ID, or bad SCCI. |
blocked | This is caused by AFA, excessive delay, or mismatched protocol. |
fault | This is caused by bad M value, bad symmetry, bad offset, or |
| duplicate link ID. |
far end Tx link unusable | This is caused by the far end reporting Tx unusable in the ICP |
| cells. |
far end Rx link unusable | This is caused by the far end reporting Rx unusable in the ICP |
| cells. |
no failure | The link has no failure. |
|
|
Tx
Rx
Operation Link
Rx Test
Test
Viewing IMA Group To view IMA status for a selected group, follow these steps:
Status
1From the Configuration Management menu, select [1] Manage Card.
2From the List Card menu, select the number corresponding to the slot in which the T1 UNI or E1 UNI card is installed to open the Group Menu.
3Select [4] IMA Group Status to open the Group Status Selection menu, shown in Figure 71.