
Installation Procedures | 51 |
Connecting to the Ethernet Port
To connect to the Ethernet port, run a cable from the port to the LAN. The Link LED illuminates if you make the connection properly. The cable run from the PathBuilder S330/S310 Ethernet port to the Ethernet LAN connection must be no longer than 100 meters, in compliance with EIA/TIA standards for 10BaseT. This cable length should include service loops at the ends and the complete cable route distances.
Ethernet Port LEDs In addition to the common LEDs described earlier in this chapter, the following LEDs indicate the status of the Ethernet port. See Figure 21.
TX data
RX data
Link
Figure 21 PathBuilder S330/S310 Ethernet Port LEDs
Link
RX data
TX data