
|
| Managing System Alarms 173 |
Table 28 DS1/E1 UNI Module Alarms (continued) |
| |
|
|
|
Alarm | Meaning | Troubleshooting Steps |
Group [n] Dup. IMA | The same group IMA ID has |
ID | been received on links |
| belonging to different IMA |
| groups in the same card. |
Correct link or group configuration.
Group [n] FE Abort | The far end rejects the |
Symmetry | symmetry sent by the near end. |
Group [n] FE | The far end reports it is not |
Blocked | passing data. |
ATM Forum |
|
Group [n] FE Config | The far end rejects the M value |
Abort | used by the near end. |
Check and correct near end symmetry. Only symmetric operation is supported in PathBuilder products.
Check and repair link facilities. Verify configuration.
Configure both ends to the same M value.
NOTE: This alarm should not occur if both ends are PathBuilder S310, S330, S600, or S700 products.
Group [n] FE Start | The far end is coming up |
Up | (starting IMA). |
ATM Forum |
|
Group [n] FE | The far end node is reporting |
Insufficient Links | an insufficient number of links. |
ATM Forum |
|
Group [n] | The near end finds not enough |
Insufficient Links | available links. |
ATM Forum | This occurs when the near end |
| has completed parameter |
| negotiation with the far end, |
| but is neither passing data nor |
| blocked. |
Information about far end state.
Check and repair link facilities. Verify configuration.
Check and correct any faulty IMA links. Check and correct IMA minimum links parameter.
Group [n] Lack of | The near end is idling because |
Link | it does not have enough links |
| in an IMA group. This occurs |
| only after group parameters |
| are negotiated. When this |
| occurs, the “NE Insufficient |
| Links” alarm is also reported. |
Take the group down, and stop passing data in all links.
Group [n] Link | Summary information alarm to | Information only. |
Down | indicate one or more alarms on |
|
| this IMA group are active. |
|
Group [n] Link Up | Summary informational alarm | Information only. |
| to indicate all alarms on the |
|
| IMA group are cleared. |
|
Group [n] N<P | There are fewer configured | Continue passing data. |
| links than IMA links required to |
|
| make an IMA group active. |
|
Group [n] No Link | The near end has lost all its |
| links in an IMA group because |
| these links have AFA, LOS, AIS, |
| OOF, LCD, or missing ICP cells. |
| This invalidates all the far end |
| identity. |
(continued) |
|
If one or more links comes back,