3Com S330 manual Configuring the Local Host IP Address, Manage IP Network Configuration Menu

Performing Initial System Configuration 65

Figure 35 Manage IP Network Configuration Menu

Configuring the Local Host IP Address

In order for the PathBuilder S330/S310 to communicate on the network, you must use the VT100 terminal to assign an IP address to the device. Once you have entered the IP address for the PathBuilder S330/S310 on the VT100 terminal, you can continue configuring the device on the local console, or you can use a Telnet session to configure the device on a TCP/IP workstation.

To enter an IP address for the PathBuilder S330/S310, follow these steps:

1From the Manage IP Network Configuration menu, select [1] Local Host IP Configuration to display the Local Host IP Configuration menu, shown in Figure 36.

When you apply a change to this menu, you might get logged out if you are using a Telnet session. The default VT100 configuration is Baud rate: 9600, Parity; none, Data Bits:8, StopBits:1.

Figure 36 Local Host IP Configuration Menu