SUPPLEMENTARY REGULATORY
INFORMATION
| This section describes the compliance of the SuperStack® II PathBuilder® S330 |
| and the SuperStack® II PathBuilder® S310 WAN access switches (PathBuilder |
| S330/S310) with FCC, Industry Canada, and CE regulations. |
|
|
FCC Part 68 Statement | This equipment complies with Part 68 of the Federal Communications |
| Commission (FCC) rules. On the product is a label that contains the FCC |
| registration number for this device. If requested, you must provide this |
| information to the telephone company. |
| This equipment is designed to be connected to the telephone network or |
| premises wiring using a compatible modular jack which is Part 68 compliant. |
| See installation instructions for details. |
| If this device causes harm to the telephone network, the telephone company |
| will notify you in advance that temporary discontinuance of service may be |
| required. The telephone company may request that you disconnect the |
| equipment until the problem is resolved. |
| The telephone company may make changes in its facilities, equipment, |
| operations, or procedures that could affect the operation of this equipment. If |
| this happens, the telephone company will provide advance notice in order for |
| you to make necessary modifications to maintain uninterrupted service. |
| If you experience trouble with this equipment or for repair or warranty |
| information, please follow the applicable procedures explained in the Technical |
| Support section of this manual (Appendix A). |
|
|
Canadian | The Industry Canada label identifies certified equipment. This certification means |
Approval Information | that the equipment meets certain telecommunications network protective, |
| operational, and safety requirements. Industry Canada does not guarantee the |
| equipment will operate to your satisfaction. |
| Before installing this equipment, you should ensure that it is permissible to be |
| connected to the facilities of the local telecommunications company. You must |
| also install the equipment using an acceptable method of connection. In some |
| cases, the inside wiring associated with a single line individual service may be |
| extended by means of a certified connector assembly. You should be aware that |
| compliance with the above conditions may not prevent degradation of service in |
| some situations. |