3Com S330 manual Add Virtual Circuit Screen with Side a Completed

138CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS

Figure 108 Add Virtual Circuit Screen with Side A Completed

Some parameters that appear on the Add Virtual Circuit screen may not apply to the particular circuit you are configuring. The system skips any non-applicable parameters and does not allow you to set them. In addition, certain parameters may be displayed for information only; you cannot change these read-only values.

5Select the slot number corresponding to the module by which you are connected to the network for side B of the circuit.

6Repeat steps 3 and 4 for side B of the circuit. After you enter the last parameter for side B, the following prompt appears at the bottom of the screen:

Enter Admin. Status (1=out of service, 2=in service [2]):

7Set the administrative status for the circuit. The following prompt appears at the bottom of the screen:

Is the above information correct (y/n)?

8Enter y to confirm your configuration. Figure 109 shows a completed data port VCC circuit. As shown in the figure, the following message appears at the bottom of the screen:

VC has been added.

Press any key to continue.