
Managing System Alarms 171
DS1/E1 UNI Module Alarms
Table 28 describes the alarms specific to the DS1 UNI and E1 UNI modules.
ATM Forum required alarms are indicated by the notation ATM Forum
Table 28 DS1/E1 UNI Module Alarms
Alarm | Meaning | Troubleshooting Steps |
AFA Link Removal Automatic Frequency Adjustment - Link removed from physical line group due to error rate in CRC check of T1/E1 exceeding user specified rate for a given period of time.
Check the removed link for the CRC errors.
Bad IMA ID | A link within the group has |
| received an IMA ID from the far |
| end that is different than when |
| the group was initialized (and |
| from the other links in the |
| group). The link with the bad |
| IMA ID is probably |
| misconnected. |
Check the links for proper connection. Reconnect if necessary.
Bad Link ID | Each IMA group assigns a |
| unique Transmit link ID to each |
| link in the group. This link ID |
| should match the Receive link |
| ID of the remote end IMA |
| device. This alarm means that a |
| link was operating correctly, |
| but then received a Transmit |
| link ID already assigned to a |
| previous link. |
| A Tx Misconnected alarm is |
| also generated. |
Bad M | The far end frame size M has |
| changed in an IMA link. |
| The maximum value for the |
| frame size on the local device’s |
| serial card must match the |
| maximum value for the frame |
| size of the connected device. |
| The link with the BAD M is |
| probably misconnected. |
Check the links for proper connection. Reconnect if necessary.
Check to make sure the maximum frame size is set to the same value on the local and remote ends.
Bad Offset | Far end ICP cell offset has |
| changed in an IMA link. |
| Each IMA group assigns a |
| unique Transmit offset to each |
| link in the group. This alarm |
| means that a link was |
| operating correctly, but then |
| received a Transmit offset |
| already assigned to a previous |
| link. |
| A Tx Misconnected alarm is |
| also generated. |
(continued) |
|
Check the links for proper connection. Reconnect if necessary.