3Com S330 manual VCM VCC Add Virtual Circuit Screen with Side a Completed

146CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS

Figure 116 Configuring Side A of A VCM VCC Virtual Circuit

When you have entered a setting for each parameter, the Add Virtual Screen again displays the list of PathBuilder S330/S310 modules and ports by slot number and prompts you to enter a slot number for side B of the circuit, as shown in

Figure 117.

Figure 117 VCM VCC Add Virtual Circuit Screen with Side A Completed

4Select the slot number corresponding to the module by which you are connected to the network for side B of the circuit.

5Repeat steps 3and 4 for side B of the circuit. The following prompt appears at the bottom of the screen:

Is the above information correct (y/n)?

6Enter y to confirm your configuration. Figure 118 shows a completed VCM VCC circuit. As shown in the figure, the following message appears at the bottom of the screen:

VC has been added.

Press any key to continue.