3Com S330 manual Access Virtual Circuits by Port/Group Screen

Configuring Virtual Circuits 159

Figure 128 Access Virtual Circuits by Port/Group Screen

The Access Virtual Circuits by Port/Group screen provides the same information as the List Virtual Circuit screen. See “Viewing Virtual Circuits for the Entire Chassis” earlier in this section for details.

To view detailed information about one of the listed circuits, enter the desired VC# to open the Access Virtual Circuits by Port/Group detail screen. This screen provides the same information as the List Virtual Circuits Detail screen, shown earlier in Figure 126. See “Viewing Virtual Circuits for the Entire Chassis” earlier in this section for details.

From the Access Virtual Circuits by Port/Group detail screen, you can:

■Enter s to view statistics for the selected circuit.

■Enter d to delete the circuit.

■Enter m to modify the circuit.

Modifying Existing To modify an existing virtual circuit, follow these steps:

Virtual Circuits

1From the Virtual Circuit menu, select [3] Modify Virtual Circuit. The Modify Virtual Circuit selection screen appears. This screen displays a list of existing virtual circuits.

2Enter the VC# of the circuit you want to modify.

The following prompt appears:

Enter Description (12 characters maximum): <circuit description>

where <circuit description> is the Description for the selected circuit.

3If desired, change the circuit description by backspacing and typing over the existing description; otherwise, press [Return] to change other circuit parameters.

4Follow the prompts that appear at the bottom of the screen to modify the circuit parameters as desired.