
80CHAPTER 4: CONFIGURING PATHBUILDER S330/S310 MODULES, PORTS, AND APPLICATIONS
Updating the Flash File The flash file system contains system configuration information which is System automatically saved in flash memory at a predetermined interval. To update the
flash file system immediately, rather than at the next scheduled interval, follow these steps:
1From the System Administration menu, select [8] Update Flash File System. The following prompt appears:
Do you want to update the flash file system (Y/N) [N]?
2Enter y to update the flash file system.
CAUTION: The user configuration data is automatically saved into flash memory every minute. If there is a system failure (for example. a power failure), any changes that you make during the
Resetting the Interface The PathBuilder S330/S310 software allows you to reset only the MCPU interface Card card and the Voice Compression module (VCM) card. Resetting the MCPU reboots the system. To reset the MCPU interface card or the VCM card, follow these steps:
If you reset the MCPU interface card, you will terminate your Telnet session.
1From the System Administration menu, select [9] Reset Interface Card. You are prompted to select the card you want to reset.
2Enter the option corresponding to the card you want to reset (MCPU or VCM). The following prompt appears:
Are you sure you want to reset this card (Y/N) [N]?
3Enter y to reset the selected card.
Viewing an Equipment To view information about the modules currently installed on your PathBuilder List S330/S310:
From the System Administration menu, select [10] Show Equipment List. Figure 49 shows a representative Equipment List.