HP ew2500 802.11b/g Print Server manual Upgrade Tftp server IP Version Product Number Filename

Table 3-2TFTP configuration file parameters (continued)

upgrade:

Set the name and location of a firmware upgrade file for the HP Jetdirect print servers.

CAUTION: Ensure that command parameters are properly entered. Verify that the upgrade file is a higher version than the currently installed version. The print server attempts to upgrade when the upgrade file contains a higher version than the installed version.

The following is the command format:

upgrade: <TFTP server IP> <Version> <Product Number> <Filename>

The following defines the parameters:

<TFTP Server IP> IP address of the TFTP server.

<Version> Firmware version of the upgrade file.

<Product Number> Print server product number.

<Filename> Path and filename of the firmware upgrade file.

usb-mode:

USB port communication mode on the HP Jetdirect print server.

◦Auto (default): Automatically negotiate and set the highest communication mode possible for the attached printer or device.

◦MLC: HP proprietary communication mode (multiple logical channels) that allows multiple channels of simultaneous print, scan, and status communications.

◦BIDIR: Standard connection that supports bi-directional communication between the printer and print server. The print server sends print data and receives status from the printer.

◦UNIDIR: Standard connection in which data is transferred in one direction only (to the printer).

usb-speed:

(Read-only parameter, USB 2.0 products only.) Auto-negotiated communication speed over the USB connection between the HP Jetdirect print server and the device.

◦Full Speed: 12 Mbits/sec as specified in the USB v2.0 specifications, compatible with USB v1.1 specifications.

◦Hi-Speed: 480 Mbits/sec for USB v2.0 devices only.

◦Disconnected: USB port is not connected.

hw-acclrn-conf

Use hardware acceleration. 0: Disable. 1 (default): Enable.

status-page-lang:

Page description language (PDL) that the print server uses to send the HP Jetdirect configuration/status page to the printer.

◦Auto (default): Auto-detected when the print server is turned on or after a cold reset.

◦PCL: Hewlett-Packard Printer Control Language.

◦ASCII: Standard ascii characters.

◦HPGL2: Hewlett-Packard Graphics Language (v2).

◦PS: PostScript language.

IPv4 configuration 35