HP ew2500 802.11b/g Print Server manual 7TCP/IPv6 tab

Table 4-6TCP/IP(v4) tab (continued)

Item	Description
IP Address	Manually assign the IP address on the HP Jetdirect print server.
	This IP address uniquely identifies a node on a TCP/IP network. Duplicate IP addresses on a
	TCP/IP network are not allowed.
Subnet Mask	Manually assign a subnet mask if subnetting is used. A subnet mask is a 32-bit number. When
	applied to an IP address, the subnet mask determines which bits specify the network and
	subnet, and which bits uniquely specify the node.
Default Gateway	IP address of a router or computer that is used to connect to other networks or subnetworks.

TCP/IP(v6) tab

Use the TCP/IP(v6) tab to enable IPv6 operation, view IPv6 auto-configuration addresses, or manually configure IPv6 addresses. For basic information on IPv6 addresses on the print server, see TCP/IP configuration on page 14. For additional parameters that you can configure, see the Advanced tab.

Table 4-7TCP/IP(v6) tab

Item	Description
IPv6 Enable	Select or clear the check box to enable or disable IPv6 operation.
Link-Local Address	(Read only parameter.) Print server's IPv6 link-local address and prefix length. The print
	server configures this address automatically. The link-local address allows the print
	server to communicate with other IPv6 hosts on the local link without routers.
Stateless Addresses	Select or clear the check box to enable or disable the use of stateless addresses.
	NOTE: Changes to the stateless addresses normally takes place when the print server
	is turned off then turned on. You can immediately implement any stateless address
	changes by clearing and then selecting the IPv6 Enable check box.
	(Read only parameters.) The stateless addresses and prefix lengths configured on the
	print server are listed. Stateless addresses are assigned under the control of a router.

Networking tab 77