HP ew2500 802.11b/g Print Server manual RTT Average, Ping in Progress, Refresh, Link Speed

Table C-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
		RTT Average	Average RTT, from 0 to 4096 milliseconds, for packet
			transmission and response.
		Ping in Progress	Yes a test is in progress. No a test completed or is not
			running.
		Refresh	Update the ping test data with current results.
			Yes: Update the data.
			No: Maintain the existing data. (Automatically
			refreshes when the menu times out or you manually
			return to the main menu.)
Link Speed			Set the print server's link speed. The available settings
			depend on the device and installed print server. Select
			one of the following modes:
			Auto (default): Use auto-negotiation to configure the
			highest link speed and communication mode allowed.
			If auto-negotiation fails, either 100TX HALF or 10TX
			HALF is set depending on the detected link speed of
			the hub/switch port. (A 1000T half-duplex selection is
			not supported.)
			10T Half: 10 Mbps, half-duplex operation.
			10T Full: 10 Mbps, full-duplex operation.
			100TX Half: 100 Mbps, half-duplex operation.
			100TX Full: 100 Mbps, full-duplex operation.
			100TX Auto: Limits auto-negotiation to a maximum link
			speed of 100 Mbps on 1000T networks.
			1000TX Full: 1000 Mbps, full-duplex operation.
			CAUTION: Changing the link setting can cause the
			loss of network communication with the print server.
Print Protocols			Print a page that lists the configuration of the following
			protocols: IPX/SPX, Novell NetWare, AppleTalk,
			DLC/LLC.

184 Appendix C HP Jetdirect control panel menus (V.40.xx)