HP ew2500 802.11b/g Print Server IPP Printing, HP XML Services, Certificate Mgmt Service, Address

Table 4-13Miscellaneous Settings (continued)

Item	Description
IPP Printing	Use IPP on the HP Jetdirect print server. If the printer is properly connected and accessible,
	IPP allows printing to this device over the Internet (or intranet). A properly configured IPP
	client system is also required. For information on IPP client software, see HP software
	solutions summary on page 7.
HP XML Services	Allow access by HP Web service applications to XML-based data on the HP Jetdirect print
	server.
Certificate Mgmt Service	Allow HP Web Jetadmin to access and service your certificate configuration.
Web Services Print	Use the Microsoft Web Services for Devices (WSD) Print services supported on the
	HP Jetdirect print server.
WS-Discovery	Use the Microsoft Web Services Dynamic Discovery (WS Discovery) protocols on the print
	server.
LLMNR	Indicates whether link local multicast name resolution (LLMNR) requests are responded to
	over IPv4 and IPv6.
Link settings	(For wired 10/100/1000T Ethernet) Set the print server's link speed and communication
	mode. The available selections depend on the print server model.
	CAUTION: If you change the link setting, network communications with the print server
	and network device might be lost.
	● AUTO (default) Use auto-negotiation to configure itself with the highest link speed
	and communication mode allowed. If auto-negotiation fails, either 100TX HALF or
	10TX HALF is set, depending on the detected link speed of the hub/switch port. (A
	1000T half-duplex selection is not supported.)
	● 10T-Full10 Mbps, full-duplex operation.
	● 10T-Half10 Mbps, half-duplex operation.
	● 100TX-Full100 Mbps, full-duplex operation.
	● 100TX-Half100 Mbps, half-duplex operation.
	● 100TX-AUTOLimit auto-negotiation to a maximum link speed of 100 Mbps.
	● 1000T FULL 1000 Mbps, full-duplex operation.
Locally Administered	(Supported print servers only) Warning: Changing the locally administered address results
Address	in the loss of connectivity to the browser.
	Specify a locally administered address (LAA) to replace the factory assigned LAN
	Hardware (MAC) address. If used, enter a string of exactly 12 hexadecimal digits.
	For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or XE,
	where X is any hexadecimal digit 0 through F.
	The default address is the factory assigned address.
Syslog Facility	Identify the source facility of a message. Typically used to identify the source of selected
	messages during troubleshooting. By default, the HP Jetdirect print server uses LPR as the
	source facility code. However, you can use values of local0 through local7 to isolate
	individual or groups of print servers.
HTTP Idle Timeout	Length of time after which an idle HTTP connection is closed. Applies to the time after an
	HTTP request or response completes. Enter from 5 to 60 seconds. The default is 15.
	Set to zero (0) to disable. (The TCP/IP idle timeout value is used.)

86 Chapter 4 HP Embedded Web Server (V.40.xx)