Changing the Network Configuration
Management Setup Menu Screens 6-3
6.2 CHANGING THE NETWORK CONFIGURATION
Use the Network Configuration Menu screen (Figure6-2) for any of the following:
•Access the screens needed to set the bootup option.
•Configure the switch’s Internet Protocol (IP) parameters.
•Enable the on-board Web Agent.
•Set the number of concurrent Telnet sessions allowed.
The screen shown below is described in the following table.
Figure 6-2 Network Configuration Menu Screen
Startup Configuration Used to disable the extended system diagnostics during
system bootup routine for faster boot ups. For details, refer to
Section6.6 .
TFTP Download Downloads new version of firmware to update your system
(in-band). For details, refer to Section 6.7.
Selection Description
IP Configuration
IP Connectivity Test (Ping)
HTTP Configuration
MAX Number of allowed Telnet sessions (1-4) : 4
Physical Address : XX-XX-XX-XX-XX-XX
<SAVE> <RETURN> <CANCEL>
3583_10