Enterasys Networks 5G1XX, 5H1XX manual 10.15.1Port Locking, 10.15.2Unlocking the Port, Vlan ID

Configuring the Unicast Address Table

To configure the Unicast Address Table, proceed as follows:

1.Select Network Monitor Menu from the Main Menu.

2.Select Unicast Address Table.

3.As desired, set the Aging Time for the table, or view, search or clear entries by MAC address or

VLAN ID.

To configure a specific MAC address in the table, proceed as follows:

1.From the Network Monitor Menu, select Static Unicast Address Table Configuration.

2.For the MAC address, specify the VLAN ID, switch port, and the Status (Permanent, Delete On Reset, Lock Port, Unlock Port, Invalid, Delete On Time Out, or Other).

3.Highlight the Set field and press ENTER.

10.15.1Port Locking

When a port is locked, the following conditions exist:

•Any existing addresses for the selected port are cleared from the Unicast Table.

•If a MAC address was not entered, then the first address received on the port is locked in and is the only source address recognized on that port.

•If a MAC address was entered, then that MAC address becomes the locked port address.

•Locked Port MAC addresses are displayed with a Status of Lock Port in the Static Unicast Address Table Configuration Menu.

•On the LM Screen under Network Monitor Menu Unicast Address Table, the lock port MAC address entries are displayed with an L.

•Locked Ports are stored in NVRAM and are retained through board resets.

•Re-locking a locked port will clear existing entries and start the lock procedure again, either taking the next MAC address if no MAC entry was entered, or using the entered MAC address.

10.15.2Unlocking the Port

When a port is unlocked, the following conditions exist:

•All locked entries for that port are cleared.

•New MAC Address entries will show up normally.

•Re-unlocking an unlocked port will have no effect.

Configuring and Monitoring the Switch 10-11