
Downloading a Software Upgrade
3.For the Mirror Source Port, select the stack unit and port number.
4.For the Mirror Target Port, select the stack unit and port number.
5.Set the Status field to ENABLED.
6.Connect a traffic analyzer or RMON probe to the mirroring port.
10.9 DOWNLOADING A SOFTWARE UPGRADE
You can upgrade the operational software in the switch without physically opening the switch or being in the same location. The software storage sector in the flash memory of the switch is reprogrammed, allowing you to easily download software feature enhancements and problem fixes to the switch from a local or remote location.
Software can be downloaded to the switch in two ways:
•Via the serial port. This procedure is an
•Via TFTP download. This procedure uses a TFTP server connected to the network and downloads the software using the TFTP protocol. A TFTP download is much faster than a serial download, requiring only a few seconds, and can be used to upgrade a switch that is not physically in the area. The disadvantage is that this method requires a TFTP server and additional setup.
10.9.1 Downloading via the Serial Port
A serial download is the easiest method to upgrade the switch software, requiring the least amount of equipment and configuration.
To download switch software via the serial port, proceed as follows:
1.With the console port connected, reset the switch by powering the switch off and then on.
2.After the
(D)ownload System Image or (S)tart Application: [S]
3.Press “D” to download system firmware. The following message displays:
Select the Firmware Type to Download (1)Runtime (2)POST (3)Mainboard [1]:
Configuring and Monitoring the Switch