D-Link dws-1008 manual Set service-profile tkip-mc-time, Set service-profile transmit-rates

set service-profile tkip-mc-time

Changes the length of time that AP radios use countermeasures if two message integrity code (MIC) failures occur within 60 seconds. When countermeasures are in effect, DWL-8220APs dissociate all TKIP and WPA WEP clients and refuse all association and reassociation requests until the countermeasures end.

Syntax: set service-profile name tkip-mc-time wait-time

name Service profile name.

wait-timeNumber of milliseconds (ms) countermeasures remain in effect.You can specify from 0 to 60,000.

Defaults: The default countermeasures wait time is 60,000 ms (60 seconds).

Access: Enabled.

Usage: Countermeasures apply only to TKIP and WEP clients. This includes WPA WEP clients and non-WPA WEP clients. CCMP clients are not affected.

The TKIP cipher suite must be enabled. The WPA IE also must be enabled.

Examples: The following command changes the countermeasures wait time for service profile sp3 to 30,000 ms (30 seconds):

DWS-1008# set service-profile sp3 tkip-mc-time 30000 success: change accepted.

See Also:

•set service-profile cipher-tkip

•set service-profile wpa-ie

•show service-profile

set service-profile transmit-rates

Changes the data rates supported by DWL-8220APs for a service-profile’s SSID.

Syntax: set service-profile name transmit-rates {11a 11b 11g} mandatory rate-list[disabled rate-list] [beacon-rate rate] [multicast-rate {rate auto}]

D-Link DWS-1008 CLI Manual 386