D-Link dws-1008 manual Link DWS-1008 CLI Manual 355, Portal-acl setting

Table: Defaults for Radio Profile Parameters (continued)

Parameter	Default Value	Radio Behavior When Parameter Set to Default Value
user-idle-timeout	180	Allows a client to remain idle for 180 seconds (3 minutes) before
		MSS changes the client’s session to the Disassociated state.
		If set to portalacl and the service profile fallthru is set to web-
	portalacl	portal, radios use the portalacl ACL to filter traffic for Web Portal
		users during authentication.
	Note: This is the default only if	If the fallthru type is not web-portal, radios do not use the web-
web-portal-acl	the fallthru type on the service
	profile has been set to web-	portal-acl setting.
	portal. Otherwise, the value is
	unconfigured.
web-portal-form	Not configured	For WebAAA users, serves the D-Link login page.
web-portal-	5	Allows aWeb PortalWebAAA session to remain in the Deassociated
		state 5 seconds before being terminated automatically.
session-timeout
		Uses dynamic WEP rather than static WEP.
wep key-index	No Keys defined	Note: If you configure a WEP key for static WEP, MSS continues
		to also support dynamic WEP.
web active-	1	Uses WEP key 1 for static WEP encryption of multicast traffic if
		WEP encryption is enabled and keys are defined.
multicast-index
wep active-unicast	1	Uses WEP key 1 for static WEP encryption of unicast traffic if
		WEP encryption is enabled and keys are defined.
-index
wpa-ie	disable	Does not use the WPA IE in transmitted frames.

D-Link DWS-1008 CLI Manual 355