D-Link dws-1008 manual Show port poe, Syntax show port poe port-list, DWS-1008# show port poe

show port poe

Displays status information for ports on which Power over Ethernet (PoE) is enabled.

Syntax: show port poe [port-list]

port-listList of physical ports. If you do not specify a port list, PoE information is displayed for all ports.

Defaults: None.

Access: All.

Examples: The following command displays PoE information for all ports on a DWS-1008:

DWS-1008#show port poe
Link	Port	PoE	PoE
Port Name Status	Type	config	Draw

==============================================================

1	1	up	-	disabled	off
2	2	down	-	disabled	off
3	3	down	-	disabled	off
4	4	down	-	disabled	off
5	5	down	-	disabled	off
6	6	up	AP	enabled	1.44
7	7	down	-	disabled	invalid
8	8	down	-	disabled	invalid

The table below describes the fields in this display.

Field	Description
Port	Port number.
Name	Port name. If the port does not have a name, the port number is
	listed.
Link status	Link status of the port:
	• up—The port is connected.
	• down—The port is not connected.
Port type	Port type:
	• AP—The port is an AP access port.
	• - (The port is not an AP access port.)
PoE config	PoE state:
	• enabled
	• disabled
PoE Draw	Power draw on the port, in watts.
	For 10/100 Ethernet ports on which PoE is disabled, this field
	displays off. The value overcurrent indicates a PoE problem
	such as a short in the cable.

D-Link DWS-1008 CLI Manual 57