D-Link dws-1008 manual Set snmp usm, Creates a USM user for SNMPv3

set snmp usm

Creates a USM user for SNMPv3.

Note: This command does not apply to SNMPv1 or SNMPv2c. For these SNMP versions, use the set snmp community command to configure community strings.

Syntax: set snmp usm usm-usernamesnmp-engine-id {ip ip-addr local hex hex-string}

access {read-only read-notify notify-only read-write notify-read-write} auth-type {none md5 sha} {auth-pass-phrase string auth-key hex-string} encrypt-type {none des 3des aes}

{encrypt-pass-phrase string encrypt-key hex-string}

usm-username	Name of the SNMPv3 user. Specify between 1 and 32
	alphanumeric characters, with no spaces.
snmp-engine-id {ip ip-addr	Specifies a unique identifier for the SNMP engine. To send
local hex hex-string}	informs, you must specify the engine ID of the inform receiver.
	To send traps and to allow get and set operations and so on,
	specify local as the engine ID.
	• hex hex-string—ID is a hexadecimal string.
	• ip ip-addr—ID is based on the IP address of the station
	running the management application. Enter the IP address
	of the station. MSS calculates the engine ID based on the
	address.
	• local—Uses the value computed from the switch’s system
	IP address.

access {read-only read-notify notify-only read-write notify-read-write}

Specifies the access level of the user:

•read-only—An SNMP management application using the string can get (read) object values on the switch but cannot set (write) them.

•read-notify—An SNMP management application using the string can get object values on the switch but cannot set them. The switch can use the string to send notifications.

•notify-only—The switch can use the string to send notifications.

•read-write—An SNMP management application using the string can get and set object values on the switch.

•notify-read-write—An SNMP management application using the string can get and set object values on the switch. The switch can use the string to send notifications.

D-Link DWS-1008 CLI Manual 113