Examples: The following command configures Distributed AP 1 to use IP address 172.16.0.42 with a 24-bit netmask, and use 172.16.0.20 as its default gateway:

DWS-1008#set dap 1 boot-ip ip 172.16.0.42 netmask 255.255.255.0 gateway

172.16.0.20mode enable success: change accepted.

See Also:

clear dap boot-configuration

set dap boot-switch

set dap boot-vlan

show dap boot-configuration

set dap boot-switch

Specifies the DWS-1008 a Distributed AP contacts and attempts to use as its boot device.

Syntax: set dap dap-numboot-switch [switch-ip ip-addr] [name name dns ip-addr] [mode {enable disable}]

dap dap-num

Number of the Distributed AP for which you are specifying static IP

 

information.

switch ip ip-addr

The IP address of the DWS-1008 the Distributed AP should boot

 

from.

name name

The fully qualified domain name of the DWS-1008 the Distributed AP

 

should boot from. When both a name and a switch-ip are specified,

 

the AP uses the name.

dns ip-addr

The IP address of the DNS server used to resolve the specified

 

name of the DWS-1008.

mode {enable disable}

Enables or disables the AP using the specified boot device.

Defaults: By default APs use the process described in “Default AP Boot Process”, in the D-Link Mobility System Software Configuration Guide to boot from a DWS-1008, instead of using a manually specified DWS-1008.

Access: Enabled

Usage: When you specify a boot switch for a distributed AP to boot from, it boots using the process described in “AP Boot Process Using Static IP Configuration”, in the D-Link Mobility System Software Configuration Guide.

D-Link DWS-1008 CLI Manual

318

Page 321
Image 321
D-Link dws-1008 manual Set dap boot-switch, Switch ip ip-addr