D-Link dws-1008 manual SNMPv2c with Informs, Retries num, Timeout num, SNMPv2c with Traps

security {unsecured	Specifies the security level, and is applicable only when
authenticated encrypted}	applicable only when the SNMP version is usm:
	• unsecured—Message exchanges are not
	authenticated, nor are they encrypted.
	This is the default.
	• authenticated—Message exchanges are authenticated,
	but are not encrypted.
	• encrypted—Message exchanges are authenticated
	and encrypted.
SNMPv2c with Informs

To configure a notification target for informs from SNMPv2c, use the following command:

Syntax: set snmp notify target target-numip-addr[:udp-port-number] v2c community-stringinform [profile profile-name] [retries num] [timeout num]

target-num	ID for the target. This ID is local to the switch and does not need to
	correspond to a value on the target itself. You can specify a number
	from 1 to 10.
ip-addr[:udp-port-number]	IP address of the server. You also can specify the UDP port number
	to send notifications to.
community-string	Community string.
profile profile-name	Notification profile this SNMP user will use to specify the notification
	types to send or drop.
retries num	Specifies the number of times the MSS SNMP engine will resend a
	notification that has not been acknowledged by the target. You
	can specify from 0 to 3 retries.
timeout num	Specifies the number of seconds MSS waits for acknowledgement
	of a notification. You can specify from 1 to 5 seconds.
SNMPv2c with Traps

To configure a notification target for traps from SNMPv2c, use the following command:

Syntax: set snmp notify target target-numip-addr[:udp-port-number] v2c community-stringtrap [profile profile-name]

D-Link DWS-1008 CLI Manual 109