Password (shared secret key) used to authenticate to the RADIUS server.
Number of transmission attempts made before declaring an unresponsive RADIUS server unavailable.
Number of seconds to wait for the RADIUS server to respond before retransmitting.
Number of minutes to wait after declaring an unresponsive RADIUS server unavailable before retrying the RADIUS server.

clear radius client system-ip

Removes the switch’s system IP address from use as the permanent source address in RADIUS client requests from the switch to its RADIUS server(s).

Syntax: clear radius client system-ip deadtime

key retransmit

timeout

Defaults: None

Access: Enabled.

Usage: The clear radius client system-ipcommand causes the switch to use the IP address of the interface through which it sends a RADIUS client request as the source IP address. The switch selects a source interface address based on information in its routing table as the source address for RADIUS packets leaving the switch.

Examples: To clear the system IP address as the permanent source address for RADIUS client requests, type the following command:

DWS-1008# clear radius client system-ipsuccess: change accepted.

See Also:

set radius client system-ip

show aaa

D-Link DWS-1008 CLI Manual

229

Page 232
Image 232
D-Link dws-1008 manual Clear radius client system-ip, See Also