D-Link dws-1008 manual Set ap dap group, Syntax set ap port-list dap dap-num auto group name

set {ap dap} group

Configures a named group of AP access points. MSS automatically load balances sessions among the access points in a group. To balance the sessions, MSS rejects an association request for an access point’s radio if that radio has at least four more active sessions than the radio of the same type with the least number of active sessions within the group.

Syntax: set {ap port-list dap {dap-num auto}} group name

ap port-list dap dap-num dap auto

List of AP access ports to add to the group.

Number of a Distributed AP to add to the group.

Configures an AP group for the AP configuration profile.

name	AP access point group name of up to 16 alphanumeric characters, with
	no spaces.

Defaults: AP access points are not grouped by default.

Access: Enabled

Usage: You can assign any subset or all of the access points connected to a DWS-1008 to a group on that switch. All access points in a group must be connected to the same DWS-1008.

If you use the name none, spelled in any combination of capital or lowercase letters, the specified access point is cleared from all AP groups.

Examples: The following command configures an DWL-8220AP access point group named loadbalance1 that contains the access points on ports 1, 4, and 7:

DWS-1008# set ap 1,4,7 group loadbalance1 success: change accepted.

See Also:

•show {ap dap} config

•show {ap dap} group

D-Link DWS-1008 CLI Manual 323