D-Link dws-1008 manual Radius Client, Radius Servers, Server Groups, Radius Proxy

RADIUS and Server Groups Commands

Use RADIUS commands to set up communication between a switch and groups of up to four RADIUS servers for remote authentication, authorization, and accounting (AAA) of administrators and network users. This chapter presents RADIUS commands alphabetically. Use the following table to locate commands in this chapter based on their uses.

RADIUS Client	set radius client system-ip on page 234
	clear radius client system-ip on page 229
RADIUS Servers	set radius on page 232
	set radius server on page 236
	clear radius on page 228
	clear radius server on page 231
Server Groups	set server group on page 238
	set server group load-balance on page 239
	clear server group on page 231
RADIUS Proxy	set radius proxy client on page 234
	set radius proxy port on page 235
	clear radius proxy client on page 230
	clear radius proxy port on page 230

(For information about RADIUS attributes, see the RADIUS appendix in the D-Link Mobility System Software Configuration Guide.)

D-Link DWS-1008 CLI Manual 227