D-Link dws-1008 manual Field Description, Name, Configured with set system countrycode

Field	Description
Product Name	DWS model number.
System Name	System name (factory default, or optionally configured with set system
	name).
System Countrycode	Country-specific 802.11 code required for AP operation.
	(configured with set system countrycode)
Total Power Over	Total power that the DWS-1008 is currently supplying to its directly connected
Ethernet	access points, in watts.
System Location	Record of the DWS switch’s physical location (optionally configured
	with set system location).
System Contact	Contact information about the system administrator or another person to
	contact about the system (optionally configured with set system contact).
System IP	Common interface, source, and default IP address for the DWS-1008, in
	dotted decimal notation (configured with set system ip-address).
System idle timeout	Number of seconds MSS allows a CLI management session (console, Telnet,
	or SSH) to remain idle before terminating the session. (The system idle
	timeout can be configured using the set system idle-timeoutcommand.)
System MAC	DWS-1008 media access control (MAC) machine address set at the factory,
	in 6-byte hexadecimal format.
Boot Time	Date and time of the last system reboot.
Uptime	Number of days, hours, minutes, and seconds that the switch has been
	operating since its last restart.
Fan status	Operating status of the three switch cooling fans:
	• OK—Fan is operating.
	• Failed—Fan is not operating. MSS sends an alert to the system log every
	5 minutes until this condition is corrected. Fan 1 is located nearest the front
	of the chassis, and fan 3 is located nearest the back.
Temperature	Status of temperature sensors at three locations in the DWS-1008 switch:
	• ok—Temperature is within the acceptable range of 0° C to 50° C
	(32° F to 122° F).
	• Alarm—Temperature is above or below the acceptable range. MSS
	sends an alert to the system log every 5 minutes until this condition is
	corrected.
PSU Status	Status of the lower and upper power supply units:
	• missing—Power supply is not installed or is inoperable.
	• DC ok—Power supply is producing DC power.
	• DC output failure—Power supply is not producing DC power. MSS
	sends an alert to the system log every 5 minutes until this condition is
	corrected.
	• AC ok—Power supply is receiving AC power.
	• AC not present—Power supply is not receiving AC power.

D-Link DWS-1008 CLI Manual 31