D-Link dws-1008 manual 11a 11b 11g, Mandantory rate-list, Disabled rate-list, Beacon-rate rate

name	Service profile name.
11a 11b 11g	Radio type.
mandantory rate-list	Set of data transmission rates that clients are required to support in
	order to associate with an SSID on an AP. A client must support at
	least one of the mandatory rates.
	These rates are advertised in the basic rate set of 802.11 beacons,
	probe responses, and reassociation response frames sent by AP
	radios.
	Data frames and management frames sent by APs use one of the
	specified mandatory rates. The valid rates depend on the radio type:
	• 11a - 6.0, 9.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
	• 11b - 1.0, 2.0, 5.5, 11.0
	• 11g- 1.0, 2.0, 5.5, 6.0, 9.0, 11.0, 12.0, 18.0, 24.0, 36.0, 48.0, 54.0
	Use a comma to separate multiple rates; for example: 6.0,9.0,12.0
disabled rate-list	Data transmission rates that APs will not use to transmit data. This
	setting applies only to data sent by the APs. The radios will still accept
	frames from clients at disabled data rates.
	The valid rates depend on the radio type and are the same as the
	valid rates for mandatory.
beacon-rate rate	Data rate of beacon frames sent by APs. This rate is also used for
	probe-response frames.
multicast-rate	The valid rates depend on the radio type and are the same as the
{rate auto}	valid rates for mandatory. However, you cannot set the beacon rate
	to a disabled rate.
	Data rate of multicast frames sent by APs.
	• rate - Sets the multicast rate to a specific rate.The valid rates depend
	on the radio type and are the same as the valid rates for mandatory.
	However, you cannot set the multicast rate to a disabled rate.
	• auto - Sets the multicast rate to the highest rate that can reach all
	clients connected to the AP.

D-Link DWS-1008 CLI Manual 387