target-num

ID for the target. This ID is local to the switch and does not

 

need to correspond to a value on the target itself. You

 

can specify a number from 1 to 10.

ip-addr[:udp-port-number]

IP address of the server. You also can specify the UDP port

 

number to send notifications to.

community-string

Community string.

profile profile-name

Notification profile this SNMP user will use to specify the

 

notification types to send or drop.

SNMPv1 with Traps

 

To configure a notification target for traps from SNMPv1, use the following command:

Syntax: set snmp notify target target-num ip-addr [:udp-port-number] v1 community-string [profile profile-name]

target-num

ID for the target. This ID is local to the switch and does not

 

need to correspond to a value on the target itself. You

 

can specify a number from 1 to 10.

ip-addr[:udp-port-number]

IP address of the server. You also can specify the UDP port

 

number to send notifications to.

community-string

Community string.

profile profile-name

Notification profile this SNMP user will use to specify the

 

notification types to send or drop.

Defaults: The default UDP port number on the target is 162.The default minimum required security level is unsecured. The default number of retries is 0 and the default timeout is 2 seconds.

Access: Enabled.

Usage: The inform or trap option specifies whether the MSS SNMP engine expects the target to acknowledge notifications sent to the target by the switch.Use inform if you want acknowledgements. Use trap if you do not want acknowledgements. The inform option is applicable to SNMP version v2c or usm only.

Examples: The following command configures a notification target for acknowledged notifications:

DWS-1008#set snmp notify target 1 10.10.40.9 usm inform user securesnmpmgr1 snmp-engine-id ip

success: change accepted.

D-Link DWS-1008 CLI Manual

110

Page 113
Image 113
D-Link dws-1008 manual SNMPv1 with Traps, Success change accepted Link DWS-1008 CLI Manual 110