D-Link dws-1008 manual Set igmp rv, Show igmp receiver-table, Syntax set igmp rv num vlan vlan-id

Usage: You cannot add AP access ports or wired authentication ports as static multicast ports. However, MSS can dynamically add these port types to the list of multicast ports based on multicast traffic.

Examples: The following command adds port 7 as a static multicast receiver port:

DWS-1008# set igmp receiver port 7 enable success: change accepted.

The following command removes port 4 from the list of static multicast receiver ports:

DWS-1008# set igmp receiver port 4 disable success: change accepted.

See Also:

• show igmp receiver-table

set igmp rv

Changes the robustness value for one VLAN or all VLANs on a DWS-1008 switch. Robustness adjusts the IGMP timers to the amount of traffic loss that occurs on the network.

Syntax: set igmp rv num [vlan vlan-id]

num	Robustness value. You can specify a value from 2 through 255. Set the
	robustness value higher to adjust for more traffic loss.
vlan vlan-id	VLAN name or number. If you do not specify a VLAN, MSS changes the
	robustness value for all VLANs.

Defaults: The default robustness value for all VLANs is 2.

Access: Enabled.

Examples: The following example changes the robustness value on VLAN orange to 4:

DWS-1008# set igmp rv 4 vlan orange success: change accepted.

See Also:

•set igmp oqi

•set igmp qi

•set igmp qri

D-Link DWS-1008 CLI Manual 459