D-Link dws-1008 manual Clear log trace, Syntax clear log trace Defaults None Access Enabled

Trace Commands

Use trace commands to perform diagnostic routines. While MSS allows you to run many types of traces, this chapter describes commands for those traces you are most likely to use. For a complete listing of the types of traces MSS allows, type the set trace ? command.

Caution: Using the set trace command can have adverse effects on system performance. D-Link recommends that you use the lowest levels possible for initial trace commands, and slowly increase the levels to get the data you need.

This chapter presents trace commands alphabetically. Use the following table to locate commands in this chapter based on their use.

Trace	clear log trace on page 490
	clear trace on page 491
	save trace on page 492
	set trace authentication on page 492
	set trace authorization on page 493
	set trace dot1x on page 493
	set trace sm on page 494
	show trace on page 495

clear log trace

Deletes the log messages stored in the trace buffer.

Syntax: clear log trace

Defaults: None.

Access: Enabled.

Examples: To delete the trace log, type the following command:

DWS-1008#clear log trace

See Also:

•set log

•show log buffer

D-Link DWS-1008 CLI Manual 490