D-Link dws-1008 Set service-profile cos, Defaults 40-bit WEP encryption is disabled by default

Defaults: 40-bit WEP encryption is disabled by default.

Access: Enabled.

Usage: To use 40-bit WEP with WPA clients, you must also enable the WPA IE.

When 40-bit WEP in WPA is enabled in the service profile, radios managed by a radio profile that is mapped to the service profile can also support non-WPA clients that use dynamic WEP.

To support WPA clients that use 104-bit dynamic WEP, you must enable WEP with 104-bit keys in the service profile. Use the set service-profilecipher-wep104command.

Microsoft Windows XP does not support WEP with WPA. To configure a service profile to provide dynamic WEP for XP clients, leave WPA disabled and use the set service-profile wep commands.

To support non-WPA clients that use static WEP, you must configure static WEP keys. Use the set service-profile wep key-indexcommand.

Examples: The following command configures service profile sp2 to use 40-bit WEP encryption:

DWS-1008# set service-profile sp2 cipher-wep40 enable success: change accepted.

See Also:

•set service-profile cipher-ccmp

•set service-profile cipher-tkip

•set service-profile cipher-wep40

•set service-profile wpa-ie

•show service-profile

set service-profile cos

Sets the Class-of-Service (CoS) level for static CoS.

Syntax: set service-profile name cos level

name Service profile name.

level CoS value assigned by the AP to all traffic in the service profile.

Defaults: The default static CoS level is 0.

Access: Enabled.

D-Link DWS-1008 CLI Manual 367