set dot1x bonded-period

Changes the Bonded Auth™ (bonded authentication) period. The Bonded Auth period is the number of seconds MSS allows a Bonded Auth user to reauthenticate.

Syntax: set dot1x bonded-period seconds

seconds

Number of seconds MSS retains session information for an

 

authenticated machine while waiting for a client to (re)authenticate

 

on the same machine. You can change the bonded authentication

 

period to a value from 1 to 300 seconds.

Defaults: The default bonded period is 0 seconds, which disables the feature.

Access: Enabled.

Usage: Normally, the Bonded Auth period needs to be set only if the network has Bonded Auth clients that use dynamic WEP, or use WEP-40 or WEP-104 encryption with WPA or RSN. These clients can be affected by the 802.1X reauthentication parameter or the RADIUS Session-Timeout parameter.

D-Link recommends that you try 60 seconds, and change the period to a longer value only if clients are unable to authenticate within 60 seconds.

The bonded authentication period applies only to 802.1X authentication rules that contain the bonded option.

Examples: To set the bonded authentication period to 60 seconds, type the following command:

DWS-1008# set dot1x bonded-period 60 success: change accepted.

See Also:

clear dot1x bonded-period

show dot1x

D-Link DWS-1008 CLI Manual

246

Page 249
Image 249
D-Link dws-1008 manual Set dot1x bonded-period, Syntax set dot1x bonded-period seconds