D-Link dws-1008 Set radio-profile auto-tune channel-interval, Name Rate, Name Radio profile name

name

rate

Radio profile name.

Minimum number of seconds a radio must remain on its current channel setting before RF Auto-Tuning is allowed to change the channel. You can specify from 0 to 65535 seconds.

Defaults: The default RF Auto-Tuning channel holddown is 900 seconds.

Access: Enabled.

Usage: The channel holddown applies even if RF anomalies occur that normally cause an immediate channel change.

Examples: The following command changes the channel holddown for radios in radio profile rp2 to 600 seconds:

DWS-1008# set radio-profile rp2 auto-tunechannel-holddown 600 success: change accepted.

See Also:

•set radio-profile auto-tune channel-config

•set radio-profile auto-tune channel-interval

•set radio-profile auto-tune channel-lockdown

•show radio-profile

set radio-profile auto-tune channel-interval

Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in a radio profile. At the end of each interval, MSS processes the results of the RF scans performed during the previous interval, and changes radio channels if needed.

Syntax: set radio-profile name auto-tune channel-interval seconds

name Radio profile name.

seconds Number of seconds RF Auto-Tuning waits before changing radio channels to adjust to RF changes, if needed. You can specify from 0 to 65535 seconds.

Defaults: The default channel interval is 3600 seconds (one hour).

Access: Enabled.

Usage: D-Link recommends that you use an interval of at least 300 seconds (5 minutes). RF Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF anomalies. Even in this case, channel changes cannot occur more frequently than the channel holddown interval.

D-Link DWS-1008 CLI Manual 336