D-Link dws-1008 manual Autoboot, Syntax autoboot on on OFF off, Boot autoboot, BT =type

autoboot

Displays or changes the state of the autoboot option. The autoboot option controls whether a DWS-1008 switch automatically boots a system image after initializing the hardware, following a system reset or power cycle.

Syntax: autoboot [ON on OFF off]

ON Enables the autoboot option.

on Same effect as ON.

OFF Disables the autoboot option.

off Same effect as OFF.

Defaults: The autoboot option is enabled by default.

Access: Boot prompt.

Examples: The following command displays the current setting of the autoboot option:

boot> autoboot

The autoboot flag is on.

See Also:

• boot

boot

Loads and executes a system image file.

Syntax: boot [BT=type] [DEV=device] [FN=filename] [HA=ip-addr] [FL=num] [OPT=option] [OPT+=option]

BT=type	Boot type:
	• c—Compact flash. Boots using nonvolatile storage or a flash card.
	• n—Network. Boots using a TFTP server.

DEV=device Location of the system image file:

•c:—Nonvolatile storage area containing boot partition 0

•d:—Nonvolatile storage area containing boot partition 1

•e:—Primary partition of the flash card in the flash card slot

•f:—Secondary partition of the flash card in the flash card slot

•boot0—boot partition 0

•boot1—boot partition 1

When the boot type is n (network), the device can be one of the following:

• mgmt or tsec0—The 10/100 port labelled Mgmt

FN=filename System image filename.

D-Link DWS-1008 CLI Manual 514