D-Link dws-1008 manual Link DWS-1008 CLI Manual 411

Field	Description
	802.11 type and configuration state of the radio.
	• The configure succeed state indicates that the AP has received configuration
	parameters for the radio and the radio is ready to accept client connections.
	• 802.11b protect indicates that the 802.11b/g radio is sending messages to
	802.11b devices, while sending 802.11g traffic at higher data rates, to inform
	the 802.11b devices about the 802.11g traffic and reserve bandwidth for the
	traffic.
	Protection mode remains in effect until 60 seconds after the last 802.11b traffic
	is detected by the 802.11b/g radio.
	• Sweep Mode indicates that a disabled radio is nonetheless participating in
	rogue detection scans. Even though this message appears only for disabled
	radios, all radios, enabled or disabled, participate in rogue detection.
	• Countermeasures Enabled indicates that the radio is sending countermeasures
	packets to combat a rogue.
	• Radar Scan indicates that the radio is performing the initial channel availability
Radio 1 type	check for Dynamic Frequency Selection (DFS). This state lasts during the first
Radio 2 type	60 seconds an 802.11a radio is on a new channel, during which time the radio
	does not transmit. If the radio does not detect any radar on the channel, the
	radio starts using the channel for data. If the radio does detect radar, the flag
	changes to Radar Detected.
	• Radar Detected indicates that DFS has detected radar on the channel. When
	this occurs, the AP stops transmitting on the channel for 30 minutes.
	If RF Auto-Tuning is enabled for channel assignment, the radio selects another
	channel and performs the initial channel availability check on the new channel,
	during which time the flag changes back to Radar Scan.
	Note: Radar Scan and Radar Detected apply only to 802.11a radios, for country
	codes that use DFS.
	• The following information appears for external antennas:
	• External antenna detected, configured as antenna-model—Indicates that an
	external antenna has been detected, and lists the antenna model configured
	on the radio. (MSSdoes not detect the specific model.
	The channel on which the radio is currently operating.
operational channel	Note: If the channel number is followed by (Auto), the value was set by RF Auto-
	Tuning.
	The power level at which the radio is currently operating.
operational power	Note: If the power setting is followed by (Auto), the value was set by RF Auto-
	Tuning.
base mac	Base MAC address of the radio.
bssid, ssid	SSIDs configured on the radio and their BSSIDs.
	Status of AeroScout asset tag support.
	• Active—The AeroScout Engine has enabled the tag report mode on the AP.
	• Inactive—The AeroScout Engine has not enabled, or has disabled, the tag
RFID Reports	report mode on the AP.
	Note: This field is displayed only if the rfid-mode option is enabled on the radio
	profile that manages the radio.

D-Link DWS-1008 CLI Manual 411