quit

Exit from the CLI session.

Syntax: quit

Defaults: None.

Access: All.

Examples: To end the administrator’s session, type the following command:

DWS-1008> quit

set enablepass

Sets the password that provides enabled access (for configuration and monitoring) to the switch.

Syntax: set enablepass

Defaults: None.

Access: Enabled.

Usage: After typing the set enablepass command, press Enter. If you are entering the first enable password on this switch, press Enter at the Enter old password prompt. Otherwise, type the old password. Then type a password of up to 32 alphanumeric characters with no spaces, and reenter it at the retype new password prompt.

Examples: The following example illustrates the prompts that the system displays when the enable password is changed. The passwords you enter are not displayed.

DWS-1008#set enablepass

Enter old password: old-password

Enter new password: new-password

Retype new password: new-password

Password changed

D-Link DWS-1008 CLI Manual

13

Page 16
Image 16
D-Link dws-1008 manual Quit, Set enablepass, Syntax quit Defaults None Access All