D-Link dws-1008 STP State, Bridge Priority, Port Cost, Port Priority, Timers, Fast Convergence

STP Commands

Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees on the virtual LANs (VLANs) configured on a switch, to maintain a loop-free network. This chapter presents STP commands alphabetically. Use the following table to locate commands in this chapter based on their use.

STP State	set spantree on page 492
	show spantree on page 502
	show spantree blockedports on page 506
Bridge Priority	set spantree priority on page 501
Port Cost	set spantree portcost on page 496
	set spantree portvlancost on page 499
	show spantree portvlancost on page 508
	clear spantree portcost on page 488
	clear spantree portvlancost on page 490
Port Priority	set spantree portpri on page 498
	set spantree portvlanpri on page 500
	clear spantree portpri on page 489
	clear spantree portvlanpri on page 491
Timers	set spantree fwddelay on page 494
	set spantree hello on page 495
	set spantree maxage on page 495
Fast Convergence	set spantree portfast on page 498
	show spantree portfast on page 507
	set spantree backbonefast on page 493
	show spantree backbonefast on page 506
	set spantree uplinkfast on page 502
	show spantree uplinkfast on page 516
Statistics	show spantree statistics on page 509
	clear spantree statistics on page 492

D-Link DWS-1008 CLI Manual 428