set spantree hello

Changes the interval between STP hello messages sent by a switch when operating as the root bridge, on one or all of its configured VLANs.

Syntax: set spantree hello interval {all vlan vlan-id}

interval

Interval value. You can specify from 1 through 10 seconds.

all

Changes the interval on all VLANs.

vlan vlan-idVLAN name or number. MSS changes the interval on only the specified VLAN.

Defaults: The default hello timer interval is 2 seconds.

Access: Enabled.

Examples: The following command changes the hello interval for all VLANs to 4 seconds:

DWS-1008# set spantree hello 4 all success: change accepted.

See Also:

• show spantree

set spantree maxage

Changes the maximum age for an STP root bridge hello packet that is acceptable to a switch acting as a designated bridge on one or all of its VLANs. After waiting this period of time for a new hello packet, the switch determines that the root bridge is unavailable and issues a topology change message.

Syntax: set spantree maxage aging-time{all vlan vlan-id}

aging-timeMaximum age value. You can specify from 6 through 40 seconds.

all Changes the maximum age on all VLANs.

vlan vlan-idVLAN name or number. MSS changes the maximum age on only the specified VLAN.

Defaults: The default maximum age for root bridge hello packets is 20 seconds.

Access: Enabled.

D-Link DWS-1008 CLI Manual

434

Page 437
Image 437
D-Link dws-1008 manual Set spantree hello, Set spantree maxage, Syntax set spantree maxage aging-timeall vlan vlan-id