D-Link dws-1008 manual DWS-1008#show dhcp-server verbose, Bound, Link DWS-1008 CLI Manual 121

The following command displays configuration and status information for each VLAN on which the DHCP server is configured:

DWS-1008#show dhcp-server verbose

Interface:	0 (Direct AP)
Status:	UP
Address Range:	10.0.0.1-10.0.0.253
Interface:	default(1)
Status:	UP
Address Range:	10.10.20.2-10.10.20.254
Hardware Address:	00:01:02:03:04:05
State:	BOUND
Lease Allocation:	43200 seconds
Lease Remaining:	12345 seconds
IP Address:	10.10.20.2
Subnet Mask:	255.255.255.0
Default Router:	10.10.20.1
DNS Servers:	10.10.20.4 10.10.20.5
DNS Domain Name:	mycorp.com

The table below displays output for show dhcp-server:

Field	Description
VLAN	VLAN number.
Name	VLAN name.
Address	IP address leased by the server.
MAC Address	MAC address of the device that holds the lease for the address.
Lease Remaining	Number of seconds remaining before the address lease expires.

The table below displays the output for show dhcp-server verbose:

Field	Description
Interface	VLAN name and number.
	Status of the interface:
Status	• UP
	• DOWN
Address Range	Range from which the server can lease addresses.
Hardware Address	MAC address of the DHCP client.
	State of the address lease:
	• SUSPEND—MSS is checking for the presence of another DHCP server on the subnet.
	This is the initial state of the MSS DHCP server. The MSS DHCP server remains in this
	state if another DHCP server is detected.
State	• CHECKING—MSS is using ARP to verify whether the address is available.
	• OFFERING—MSS offered the address to the client and is waiting for the client to send a
	DHCPREQUEST for the address.
	• BOUND—The client accepted the address.
	• HOLDING—The address is already in use and is therefore unavailable.
Lease Allocation	Duration of the address lease, in seconds.

D-Link DWS-1008 CLI Manual 121