D-Link dws-1008 manual Set radio-profile active-scan, Set radio-profile auto-tune channel-config

set radio-profile active-scan

Disables or reenables active RF detection scanning on the DWL-8220AP radios managed by a radio profile. When active scanning is enabled, DWL-8220AP radios look for rogue devices by sending probe any requests (probe requests with a null SSID name), to solicit probe responses from other access points.

Passive scanning is always enabled and cannot be disabled. During passive scanning, radios look for rogues by listening for beacons and probe responses.

Syntax: set radio-profile name active-scan {enable disable}

name Radio profile name.

enable Configures radios to actively scan for rogues.

disable Configures radios to scan only passively for rogues by listening for beacons and probe responses.

Defaults: Active scanning is enabled by default.

Access: Enabled.

Usage: You can enter this command on any DWS-1008 switch. The command takes effect only on that switch.

Examples: The following command disables active scan in radio profile radprof3:

DWS-1008# set radio-profile radprof3 active-scan disable success: change accepted.

See Also:

• show radio-profile

set radio-profile auto-tune channel-config

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the DWL-8220AP radios in a radio profile.

Syntax: set radio-profile name auto-tune channel-config {enable disable}

D-Link DWS-1008 CLI Manual 334