D-Link dws-1008 manual Show rfdetect counters, DWS-1008# show rfdetect countermeasures

Usage: This command is valid only on the seed switch

Examples: The following example displays countermeasures status:

DWS-1008#show rfdetect countermeasures
Total number of entries: 190
Rogue MAC	Type	Countermeasures	IPaddr	Port/Radio
		Radio Mac		/Channel
-----------------	-----	------------------	---------------	-------------
00:0b:0e:00:71:c0 intfr		00:0b:0e:44:55:66	10.1.1.23	dap 4/1/6
00:0b:0e:03:00:80 rogue		00:0b:0e:11:22:33	10.1.1.23	dap 2/1/11

The table below describes the fields in this display.

Field	Description
Rogue MAC	BSSID of the rogue.
	Classification of the rogue device:
	• rogue—Wireless device that is on the network but is not supposed to be on the
Type	network.
	• intfr—Wireless device that is not part of your network and is not a rogue, but
	might be causing RF interference with AP radios.
	• known—Device that is a legitimate member of the network.
Countermeasures Radio	MAC address of the D-Link radio sending countermeasures against the rogue.
MAC
IPaddr	System IP address of the switch that is managing the AP that is sending or will
	send countermeasures.
	Port number, radio number, and channel number of the countermeasures radio.
Port/Radio/Channel	For a Distributed AP, the connection number is labeled dap. (This stands for
	distributed ap.)

See Also:

• set radio-profile countermeasures

show rfdetect counters

Displays statistics for rogue and Intrusion Detection System (IDS) activity detected by the APs managed by a switch.

Syntax: show rfdetect counters

Defaults: None.

Access: Enabled.

D-Link DWS-1008 CLI Manual 278