name

enable

disable

no-client

Radio profile name.

Configures radios to dynamically select their channels when the radios are started.

Configures radios to use their statically assigned channels, or the default channels if unassigned, when the radios are started.

Configures radios to change channels regardless of client status. Without this option, a radio changes the channel only if the radio does not have any active clients on that channel.

Defaults: Dynamic channel assignment is enabled by default.

Access: Enabled.

Usage: If you disable RF Auto-Tuning for channels, MSS does not dynamically set the channels when radios are first enabled and also does not tune the channels during operation.

If RF Auto-Tuning for channels is enabled, MSS does not allow you to manually change channels.

Examples: The following command disables dynamic channel tuning for radios in the rp2 radio profile:

DWS-1008# set radio-profile rp2 auto-tunechannel-config disable success: change accepted.

See Also:

set {ap dap} radio channel

set radio-profile auto-tune channel-holddown

set radio-profile auto-tune channel-interval

set radio-profile auto-tune power-config

show radio-profile

set radio-profile auto-tune channel-holddown

Sets the minimum number of seconds a radio in a radio profile must remain at its current channel assignment before RF Auto-Tuning can change the channel. The channel holddown provides additional stability to the network by preventing the radio from changing channels too rapidly in response to spurious RF anomalies such as short-duration channel interference.

Syntax: set radio-profile name auto-tune channel-holddown holddown rate

D-Link DWS-1008 CLI Manual

335

Page 338
Image 338
D-Link dws-1008 Set radio-profile auto-tune channel-holddown, Name, Enable Disable No-client, Link DWS-1008 CLI Manual 335