D-Link dws-1008 manual Set service-profile user-idle-timeout

Defaults: This command has the following defaults:

•mandantory:

•11a - 6.0,12.0,24.0

•11b - 1.0,2.0

•11g - 1.0,2.0,5.5,11.0

•disabled - None. All rates applicable to the radio type are supported by default.

•beacon-rate:

•11a - 6.0

•11b - 2.0

•11g - 2.0

•multicast-rate - auto for all radio types.

Access: Enabled.

Usage: If you disable a rate, you cannot use the rate as a mandatory rate or the beacon or multicast rate. All rates that are applicable to the radio type and that are not disabled are supported by the radio.

The TKIP cipher suite must be enabled. The WPA IE also must be enabled.

Examples: The following command sets 802.11a mandatory rates for service profile sp1 to 6 Mbps and 9 Mbps, disables rates 48 Mbps and 54 Mbps, and changes the beacon rate to

9 Mbps:

DWS-1008#set service-profile sp1 transmit-rates 11a mandatory 6.0,9.0 disabled 48.0,54.0 beacon-rate 9.0

success: change accepted.

See Also:

• show service-profile

set service-profile user-idle-timeout

Changes the number of seconds MSS will leave a session up for a client that is not sending data and is not responding to keepalives (idle-client probes). If the timer expires, the client’s session is changed to the Dissociated state.

The timer is reset to 0 each time a client sends data or responds to an idle-client probe. If the idle-client probe is disabled, the timer is reset each time the client sends data.

D-Link DWS-1008 CLI Manual 388