D-Link DWS-1008 CLI Manual 12
Access Commands
Use access commands to control access to the Mobility Software System (MSS) (CLI). This chapter
presents access commands alphabetically. Use the following table to locate commands in this chapter
based on their use.

enable

Places the CLI session in enabled mode, which provides access to all commands required for
configuring and monitoring the system.
Syntax: enable
Access: All.
Usage: MSS displays a password prompt to challenge you with the enable password. To enable
a session, your or another administrator must have configured the enable password to this
switch with the set enablepass command.
Examples: The following command plus the enable password provides enabled access to the
CLI for the current sessions:
DWS-1008> enable
Enter password: password
DWS-1008#
Defaults: None.
Access: Enabled.

disable