D-Link dws-1008 manual Show log buffer, Facility facility-name, Matching string

show log buffer

Displays system information stored in the nonvolatile log buffer or the trace buffer.

Syntax: show log buffer [{+-}number-of-messages] [facility facility-name] [matching string] [severity severity-level]

buffer Displays the log messages in nonvolatile storage.

+- number-of-messagesDisplays the number of messages specified as follows:

	• A positive number (for example, +100), displays that number of
	log entries starting from the oldest in the log.
	• A negative number (for example, -100) displays that number of
	log entries starting from newest in the log.
facility facility-name	Area of MSS that is sending the log message. Type a space and
	a question mark (?) after show log buffer facility for a list of valid
	facilities.
matching string	Displays messages that match a string—for example, a username or
	IP address.

severity severity-levelDisplays messages at a severity level greater than or equal to the level specified. Specify one of the following:

• emergency—The switch is unusable.

• alert—Action must be taken immediately.

• critical—You must resolve the critical conditions. If the conditions are not resolved, the switch can reboot or shut down.

• error—The switch is missing data or is unable to form a connection.

• warning—A possible problem exists.

• notice—Events that potentially can cause system problems have occurred. These are logged for diagnostic purposes. No action is required.

• info—Informational messages only. No problem exists.

• debug—Output from debugging.

Defaults: None.

Access: Enabled.

D-Link DWS-1008 CLI Manual 509