set spantree portvlancost

Changes the cost of a network port or ports on paths to the STP root bridge for a specific VLAN on an switch.

Syntax: set spantree portvlancost port-listcost cost {all vlan vlan-id}

port-listList of ports. MSS applies the cost change to all the specified ports.

cost cost Numeric value. You can specify a value from 1 through 65,535. STP selects lower-cost paths over higher-cost paths.

all Changes the cost on all VLANs.

vlan vlan-idVLAN name or number. MSS changes the cost on only the specified VLAN. Defaults: The default port cost depends on the port speed and link type.

Access: Enabled.

Examples: The following command changes the cost on ports 3 and 4 to 20 in VLAN mauve:

DWS-1008# set spantree portvlancost 3,4 cost 20 vlan mauve success: change accepted.

See Also:

clear spantree portcost

clear spantree portvlancost

set spantree portcost

show spantree

show spantree portvlancost

set spantree portvlanpri

Changes the priority of a network port or ports for selection as part of the path to the STP root bridge, on one VLAN or all VLANs.

Syntax: set spantree portvlanpri port-listpriority value {all vlan vlan-id}

 

port-list

List of ports. MSS changes the priority on the specified ports.

 

priority value

Priority value. You can specify a value from 0 (highest priority) through 255

 

 

(lowest priority).

 

all

Changes the priority on all VLANs.

 

vlan vlan-id

VLAN name or number. MSS changes the priority on only the specified

 

 

VLAN.

 

 

 

D-Link DWS-1008 CLI Manual

437

Page 440
Image 440
D-Link dws-1008 manual Set spantree portvlancost, Set spantree portvlanpri, Changes the priority on all VLANs