D-LinkDWS-1008 CLI Manual
dap dap-numradio 1 radio 2
tx power
Number of a Distributed AP on which to set the transmit power.
Note: The maximum transmit power you can configure on any D-Link radio is the maximum allowed for the country in which you plan to operate the radio or one of the following values if that value is less than the country maximum: on an 802.11a radio, 11 dBm for channel numbers less than or equal to 64, or 10 dBm for channel numbers greater than 64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for 802.11b, or 14 dBm for all valid channel numbers for 802.11g.
Defaults: The default transmit power on all DWL-8220AP radio types is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.
Usage: To enable or disable one or more radios to which a profile is assigned, use the set ap radio radio-profile command. To enable or disable all radios that use a specific radio profile, use the set radio-profile command.
DWS-1008#set ap 4-6 radio 1 radio-profile rp1 mode enable success: change accepted.
set {ap dap} radio tx-power
Sets an DWL-8220AP radio’s transmit power.
Syntax: set {ap port-list dap dap-num} radio {1 2} tx-powerpower-level
ap port-listList of ports connected to the DWL-8220AP access points on which to set the transmit power.
Radio 1 of the DWL-8220AP.
Radio 2 of the DWL-8220AP.
Number of decibels in relation to 1 milliwatt (dBm). The power-level valid values depend on the country of operation.

Defaults: When you create a new profile, the radio parameters in the profile are set to their factory default values. To enable or disable all radios that use a specific radio profile, use set radio-profile.

Access: Enabled.

Examples: The following command enables radio 1 on ports 4 through 6 assigned to radio profile rp1:

331

Page 334
Image 334
D-Link dws-1008 manual Access Enabled